Stainless Steel Countersunk Composite Panel to Heavy Section
For fixing insulation panels to hot rolled purlins (4.0mm – 12.5mm steel).
| Part Number | Length (MM) | Diameter (MM) | Drill Point | Min Panel Thickness (MM) | Max Panel Thickness (MM) |
|---|---|---|---|---|---|
| 100.5SSC | 100 | 5.5 | No. 5 | N/A | 60 |
| 120.5SSC | 120 | 5.5 | No. 5 | N/A | 80 |
| 150.5SSC | 150 | 5.5 | No. 5 | 70 | 100 |
| 200.5SSC | 200 | 5.5 | No. 5 | 120 | 160 |
Heavy section screws fasten sandwich panels to hot rolled purlins (4.0mm – 12.5mm steel).
- Stainless steel provides excellent corrosion-resistance which increases the life-span of the fixing.
- Countersunk heads lie flush with the profile, and require T-25 bits.
- The fine thread provides many points of engagement with the purlin, maximising pull-out values.
- The high thread has a wider diameter than the lower thread, so that the outer sheet is well-engaged.
- The no. 5 drill point is designed to ensure a clean cut through up to 12.5mm steel, without burn-out.
For maximum fastener performance, we recommend using a tek screw driver which does not exceed 2500RPM.
| 100.5SSC | 120.5SSC | 150.5SSC | 200.5SSC | |
|---|---|---|---|---|
| A (mm) | 12.50 | 12.50 | 12.50 | 12.50 |
| B (mm) | 100.00 | 120.00 | 150.00 | 200.00 |
| C (mm) | 65.00 | 65.00 | 65.00 | 85.00 |
| D (mm) | 5.50 | 5.50 | 5.50 | 5.50 |
| E (mm) | 15.00 | 15.00 | 15.00 | 15.00 |
| F (mm) | 5.00 | 5.00 | 5.00 | 5.00 |
| 100.5SSC ⭳ | 120.5SSC ⭳ | 150.5SSC ⭳ | 200.5SSC ⭳ | |
|---|---|---|---|---|
| Pull Out (kN) - 4.00mm S275 Steel | 8.90 | 8.90 | 8.90 | 8.90 |
| Pull Out (kN) - 6.00mm S275 Steel | 9.50 | 9.50 | 9.50 | 9.50 |
| Pull Out (kN) - 8.00mm S275 Steel | 9.50 | 9.50 | 9.50 | 9.50 |
| Pull Out (kN) - 10.00mm S275 Steel | 9.50 | 9.50 | 9.50 | 9.50 |
| Pull Out (kN) - 12.00mm S275 Steel | 9.50 | 9.50 | 9.50 | 9.50 |
| Shear (kN) | 8.77 | 8.77 | 8.77 | 8.77 |
| Tensile (kN) | 11.49 | 11.49 | 11.49 | 11.49 |
